Homemade outboard motor hoist?

#050, Opportunity is covered for winter now, but the weather has been quite warm for working on projects. Today we tried out the newly completed outboard motor crane and it worked well. See photo. homemadehoist.jpg It is partly copied from the Forespar design and has an internal halyard that leads to a sheet winch. The halyard runs over Harken Exit Boxes and these were quite tricky to install in the 1 1/2″ stainless tubing. I made the pulpit/crane attachment and pivot blocks from UHMW (polyethylene), drilled one way for the 1″ pulpit and at right angles for the 1 1/2″ crane tube. David Salter (s/v #050, Opportunity)

Category: EXTERNAL FITTINGS