Cabin sole repairs

I’m going to be looking at an older Corbin 39 that has soft spots in the cabin sole. I’d like to know how the boat was built to determine how serious the damage is. Could you please tell me, if in your opinion, if soft spots in the cabin sole are structural problems related to …

Read more

Lining for the pilothouse interior?

Perhaps someone could suggest any thoughts on material to replace the teak plywood inside the pilot house….I was thinking of using a white covered plywood (?melamine) rather than the teak and then reusing the teak trim. Does anyone have any experience with this, and what kind of material did they use. Thanks. Bill Swales (#042, …

Read more

Air conditioning

Where have [others] installed AC units and dealt with the routing of air flow etc? I’m looking to put in a unit on my Corbin and would like to know the experiences of others who have gone before me. Thanks, Tom Knight, (#157, Fabled Past). a. Tom–I had a Cruisair 2-part system with reverse cycle …

Read more

Refrigeration selection?

Up until now we have not had refrigeration on the boat and just used ice blocks, quite effective for a trip of 4-5 days. Eileen has persuaded me to get a quote for refrigeration and we have visited the booths of Glacier Bay (the Cadillac brand) and C-Frost at past boat shows. I sent sketches …

Read more

Does this unusually open interior layout have enough deck support?

The question was posed regarding the layout of #189, Tangaroa V. The full set of responses is included here firstly because of the very clear and evidence-based response at the end from Marius Corbin that is both a ‘yes, it is OK’, and gives insight into the structural design of the Corbin 39. Secondly it …

Read more

If I buy a bare hull and deck, how to layout the interior?

a. Draw a layout to scale. Here is #050, Opportunity’s (although not to scale) per below . I am attaching the only sketch/schematic I have of our specific interior. It is different from all others and I made this by photographing a large drawing. Unfortunately, the lines aren’t very dark and it is NOT to …

Read more

Where can I buy pulpits, ladders, water and fuel tanks?

a. I talked with Tops’n’ Quality in Marysville Michigan and they said they have supplied many of the stainless pulpits for Corbin. I know of no vendor for the fuel tanks, I would imagine getting the tanks built will be an easy thing to do. Gene Whitney (#069, Joint Effort) b. The tanks, as far …

Read more